HP Application Recovery Manager software A.06.10 Installation and licensing guide (March 2008)

Installing Application Recovery Manager on
MC/ServiceGuard
Application Recovery Manager supports MC/ServiceGuard (MC/SG) for HP-UX.
For details on supported operating system versions, refer to the HP Application
Recovery Manager software product announcements, software notes, and references.
If your Cell Manager is to be cluster-aware, note that the virtual server IP address
should be used for licenses.
Installing a cluster-aware Cell Manager
Prerequisites
Before you install an Application Recovery Manager Cell Manager on
MC/ServiceGuard, check the following:
• Decide which systems are going to be the Primary Cell Manager and the
Secondary Cell Manager(s). All of them must have MC/ServiceGuard installed
and must be configured as cluster members.
• Application Recovery Manager Cell Manager, with recommended patches, and
all other Application Recovery Manager software components for the integrations
you want to have in the cluster, must be installed on the Primary node and each
of the Secondary nodes.
The installation procedure is standard procedure for installing the Cell Manager
system. See the
“Installingthe Application Recovery Manager Cell Manager (CM) and Installation Server(s) (IS)” on page 31.
What’s next?
When the installation has been completed, you must configure the installed Primary
Cell Manager and the Secondary Cell Manager(s), and the Cell Manager package.
Refer to the online Help index: “cluster, MC/ServiceGuard” for more information on
configuring MC/ServiceGuard with Application Recovery Manager.
Installing Application Recovery Manager on your network80