HP Application Recovery Manager software A.06.10 Installation and licensing guide (March 2008)

ReferenceApplication
See “HP StorageWorks Disk Array XP integration” on page 79.HP StorageWorks
Disk Array XP
See “HP StorageWorks Enterprise Virtual Array
integration” on page 79.
HP StorageWorks
Enterprise Virtual
Array
Remote installation of Application Recovery Manager clients
This section describes the procedure for distributing the Application Recovery Manager
software to clients using the Installation Server (remote installation).
Prerequisites
• See the http://www.hp.com/support/manuals and refer to the HP Application
Recovery Manager software product announcements, software notes, and
references for the information on supported Windows system versions, Application
Recovery Manager components, and for disk space requirements.
• At this point, you should have the Cell Manager and the Installation Server(s)
installed on your network.
NOTE:
The Installation Server must reside in a shared directory so that it is visible throughout
the network.
Distribute the software to clients using the Application Recovery Manager user
interface.
NOTE:
You cannot distribute software to clients in another Application Recovery Manager cell.
However, if you have an independent Installation Server, you can import it into more
than one cell. You can then distribute software within different cells by using the GUI
connected to each Cell Manager in turn.
Installing Application Recovery Manager on your network58