HP Application Recovery Manager software A.06.10 Installation and licensing guide (March 2008)

2. Run the omnisetup.sh command.
To run this command from the CD-ROM, type:
cd /cdrom/LOCAL_INSTALL
./omnisetup.sh -CM
To start the installation from disk:
• If you have copied the APPRM_DEPOT, AUTOPASS, and LOCAL_INSTALL
directories to your local disk in the directory, run:
cd directory/LOCAL_INSTALL
./omnisetup.sh -source directory -CM
• If you have copied the whole CD-ROM to cd_image_dir, run the
omnisetup.sh command with the -CM parameter:
cd cd_image_dir/LOCAL_INSTALL
./omnisetup.sh -CM
3. omnisetup.sh prompts you to install or upgrade the HP OpenView AutoPass
utility if you want to download and install passwords for the purchased licenses
directly through the internet from the HP password delivery center web server.
For more information on the AutoPass utility, refer to
“Obtaining and installing permanent passwords using HP OpenView AutoPass” on page 141.
It is recommended to install AutoPass.
If AutoPass is installed on MC/ServiceGuard, it must be installed on all nodes.
When prompted, press Return to install or upgrade AutoPass. If you do not want
to install or upgrade AutoPass, enter n.
If you want to install an Installation Server for UNIX on your Cell Manager, you can
do it at this point. Refer to “Installing Installation Servers for UNIX” on page 48 for
the required steps.
The installed directory structure
When the installation completes, the core Application Recovery Manager software
is located in the /opt/omni/bin directory and the Installation Server for UNIX in
the /opt/omni/databases/vendor directory. The following list shows the
Application Recovery Manager subdirectories and their contents:
Installation and licensing guide 35