Ethernet SNMP Module Installation and Reference Guide ( J2603B) 1995-10

US Robotics Courier HST Dual Standard with ASL
At the hub end: Switch 1 UP—DTR normal
Switch 5 UP—Auto Answer on ring
Switch 6 UP—carrier detect when modem is online
Switch 8 DOWN—AT command set recognized
Switch 9 UP—modem disconnects when session ended
Switch 10 UP—load software from NVRAM at power on
At the user end: Switch 1 UP—DTR normal
Switch 4 UP—modem echoes (displays) commands
Switch 5 DOWN—Auto Answer suppressed
Switch 6 UP—carrier detect when modem is online
Switch 8 DOWN—AT command set recognized
Switch 9 UP—modem disconnects when session ended
Switch 10 UP—load software from NVRAM at power on
Intel 14.4EX
At the hub end:
Issue the following AT command:
AT&FS0=1&S1&Y0&W0
At the user end:
Issue the following AT command:
AT&F&Y0&W0 (returns modem to factory default)
Telebit WorldBlazer
At the hub end:
Set the A/B switch to A
Issue the following AT command:
AT&F0&R1&W0
At the user end:
Set the A/B switch to A
Issue the following AT command:
AT&F0&W0
Modem Configuration
Modem Configuration
B-3