Ethernet SNMP Module Installation and Reference Guide ( J2603B) 1995-10

Removing the Module
The HP Ethernet SNMP Module is removed from the hub by reversing the
installation procedure described earlier in this document. Extractor handles
are provided on the module to help you remove it from the hub’s slot.
If an auxiliary module is attached to the HP Ethernet SNMP Module, the
extractor handles may not be accessible. See the auxiliary module
documentation for removal procedures.
Caution If the HP Ethernet SNMP Module is removed from the hub and inserted
into another hub, the IP address and any other configuration information
in the module’s firmware are lost. The HP Ethernet SNMP Module will
reset itself to the factory defaults when the new hub is powered on.
If you remove the HP Ethernet SNMP Module from a hub and then re-insert
it into the same hub, however, no firmware configuration information is lost.
Installation
1-6