A3512A 1063 Mpbs Short-Wave FC Adapter Installation Guide

Customer Order No.
A3512-90002
Copyright  1997
Printed in USA
A3512-96001
$
Step 3: Remove the cover and bezel.
Slide the cover off and remove the bezel with an
upward motion as shown in Figures 4 and 5.
Figure 4
Figure 5
Step 4: Prepare the FC adapter slot.
Before you touch any internal parts, be sure to
attach your ESD Strap to the chassis of the
MUX.
Remove the blank card and slot cover from the
unused FC slot. See Figure 6.
Figure 6
Step 5: Prepare the adapter.
Remove the FC adapter from its package. Being
careful not to bend the pins, remove the optical
port protector from the connector (see Figure 1).
Step 6: Insert and seat the adapter.
Grasp the top of the adapter card and gently push
it in, using a forward and backward motion. See
Figure 7.
Figure 7
Tighten the two top screws to secure the card.
Step 7: Replace the cover.
Replace the cover as shown in Figure 8. Attach
the cables and power cord.
Figure 8
Step 8: Power ON the MUX.
Power ON the MUX. It will automatically self-
test. Verify that the MUX recognizes the new FC
adapter by displaying the MUX Source ID on the
FC A/B Status Menu. If the adapter
identification does not display, rerun diagnostic
tests.
See “Using the FC Status Menu” in the MUX service manual
(A3308-90005) for additional information.
)&
V
O
RWV
%
$