Manualshelf

Installation Guide, Fifth Edition - HP 9000 rp8420 Server

ManualsBrandsHP ManualsServerHP 9000 rp8420-32 PA-8900 8x1.10GHz 3MB Server
31323334353637383940
Chapter 2
Installation
Wheel Kit Installation
40
Top and Side Cover Removal and Installation
NOTE It may be necessary to remove existing top and side covers installed on the server to complete a
specific customer configuration (install memory, I/O cards, etc.) prior to installing the covers
shipped with the wheel kit. If cover removal is not needed, go directly to the sections for
installing the top and side cover.
Figure 2-14 Cover Locations
CAUTION Observe all ESD safety precautions before attempting this procedure. Failure to follow ESD
safety precautions could result in damage to the server.
Removing the Top Cover
Step 1. Connect to ground with a wrist strap.
Step 2. At the rear of server, loosen the blue retaining screws securing the cover to the chassis.
Step 3. Slide the cover toward the rear of the chassis.
Step 4. Lift the rear of the cover up and pull away from the chassis.
Top Cover
Side Cover
Front Bezel