HP 9000 rp8420 Server - User Service Guide, Fifth Edition

ManualsBrandsHP ManualsServerHP 9000 rp8420-32 PA-8900 16x1.10GHz 3MB Server

121

122

123

124

125

126

127

128

129

130

Number Cabinet Name Partition Handle Firmware Version Comments

------ --------- -------- ---------- -------- ------------------ --------

(1) 1 0 MP 0 0 0 5.022 Master

(1) 2 0 MP 1 1 1 5.022 Slave

(3) 3 (2) 8 MP 0 0 32768 5.022 Master

(3) 4 (2) 8 MP 1 1 32769 5.022 Slave

5 0 PDHC 0 0 256 3.014 -

6 0 SFW 0 0 320 21.001 -

7 0 PDHC 1 1 257 3.014 -

8 0 SFW 1 1 321 22.002 -

(3) 9 0 PDHC 2 0 258 3.014 -

(3) 10 0 SFW 2 0 322 22.002 -

(3) 11 0 PDHC 3 1 259 3.014 -

(3) 12 0 SFW 3 1 323 22.002 -

Enter the Entities to be upgraded (Ex: 3,4,10): 6

Enter your user name: anonymous

Enter your user password: ********

Enter the ip address where the firmware can be found: 192.1.1.1

Enter the path where the firmware can be found: /dist/versionX_X

Enter the filename of the System Firmware image: pin.bin.X.X.fh

Are you sure that you want to continue(Y/N): y

**** Firmware Updating System Firmware ****

Firmware updating progress will be reported.

NOTE (1): When a SEU is connected to an rp8420 system, cabinet id 8 will be assigned to

the SEU.

(2): These entities will only be seen on the rp8420.

(3): X.X.X is the version number corresponding to the version of the System Firmware on

the other cells.

9. Ensure the entity selected was updated successfully. A successful update returns the following

message:

Firmware Update has completed successfully for all entities.

MP:CM>

An unsuccessful update results in an error message. If the FTP connection was successful,

but the update failed, a warning will be noted for the entity being updated. For example:

Firmware Update failed for entity SFW 0.DO NOT REBOOT SFW 0 until

it has been successfully updated!!! Firmware Update completed with

errors.

CAUTION: Repeat the firmware update procedure immediately for all entities failing to

update successfully. DO NOT RESET or AC POWER CYCLE until you get a message

indicating that all updates have completed successfully.

10. Verify the updated firmware revisions using the sysrev command. Example (rp8420 with

SEU):

MP:CM> sysrev

Cabinet firmware revision report

PROGRAMMABLE HARDWARE :

System Backplane : GPM FM OSP

------- ------- -------

1.002 1.002 1.002

PCI-X Backplane : LPM HS

------- -------

2.000 1.000

Core IO : Master Slave

-------- -------

2.009 2.009

LPM PDHC

Removing and Replacing a Cell Board 127