HP QLogic Converged Network Adapter Installation Guide (747713-001, September 2013)

b. Observing ESD precautions, store the transceiver in an ESD-safe place.
c. Remove the mounting bracket screws from the top of the CNA.
Figure 4 Removing the bracket
d. Remove the bracket and store it for future use.
e. Align the new mounting bracket tabs with the holes in the CNA.
IMPORTANT: Be careful not to push the bracket past the grounding tabs on the
transceiver housing. Make sure you properly align the LEDs with the holes in the bracket.
f. Install the screws that attach the CNA to the bracket.
5. Insert the CNA into the empty PCIe slot. Press firmly until the CNA is seated.
Figure 5 Fitting into the PCIe slot
6. Secure the CNA mounting bracket to the case with the panel clip or screw.
7. Replace the server case, and then tighten the screws on the case.
The CNA is now installed in the server and ready for media attachment.
HP Restricted8 Installing the QLogic CNA