HP QLogic Converged Network Adapter Installation Guide (747713-001, September 2013)

Example 1 MAC address and WWN calculations

Serial number (on CNA): _____________________

Port 2Port 1

(Port 1 MAC address + 4)

3C-4A-92-1B-82-2C

Port 2 MAC address: ___________________

(From IEEE address label)

3C-4A-92-1B-82-28

Port 1 MAC address: ___________________

MAC

address

(21:00:[Port 2 MAC address +3])

21:00:3C:4A:92:1B:82:2F

Port 2 WWN: ___________________

(21:00:[Port 1 MAC address +3])

21:00:3C:4A:92:1B:82:2B

Port 1 WWN: ___________________

WWN

Installing the CNA

The CNA uses removable optical transceivers or copper interface cables.

CAUTION: Be sure to observe the ESD precautions for this procedure as described in “Electrostatic

discharge” (page 14).

IMPORTANT: The CNA is supported in PCI Express 8 lane and larger PCIe slots only. This might

require optional PCIe riser cards or cages. For instructions on installing the riser card or cage, see

the server documentation.

To install the CNA into a server:

1. Be sure the server is powered off.

2. Remove the server case.

3. Wear an anti-static wrist strap and then remove the blank panel from an empty x8 or larger

PCIe bus slot.

NOTE: The CNA comes with a standard PCIe bracket installed. A low-profile bracket is

included in the box with the CNA. The low-profile mounting bracket is shorter than the standard

bracket (approximately 7.9 cm (3.11 inch) compared to 12.06 cm (4.75 inch) long).

HP Restricted6 Installing the QLogic CNA