EMULEX EZPilot EVA Version 2.0 User Manual (5697-6961, July 2007)

EZPilot - Installation Section Page 1
Installing EZPilot
Introduction
EZPilot™ from Emulex enables you to configure your Storage Area Network (SAN).
This section describes how to:
• Install EZPilot for a Windows EVA management server.
• Install EZPilot for a Windows non-management server.
• Install the Emulex Linux driver and utilities for a Linux non-management server.
Prerequisites
Operating System Requirements
For Windows Management and Non-Management Servers:
• x86 Windows Server 2003 Enterprise Edition Service Pack 2
• x64 Windows Server 2003 Enterprise Edition Service Pack 2
For Linux Non-Management Servers:
• Red Hat Enterprise Linux 4 (latest update)
• SUSE Linux Enterprise Server 9 (latest service pack)
• SUSE Linux Enterprise Server 10 (latest service pack)
Hardware Requirements
Single Switch Configuration (Non-redundant)
• One Windows 2003 server configured as an EVA management server
• Up to three non-management servers
• One HP StorageWorks A8002A 4Gb PCI-e HBA per server
• One HP StorageWorks Enterprise Virtual Array (EVA) 4100 storage system
• One HP StorageWorks 4/8 Base SAN switch with eight licensed ports
Additional non-management servers may be added if additional switch port licenses are purchased.
Contact your HP representative for more information.
Note: All servers must boot from a local disk. SAN boot is not supported by EZPilot.