EMULEX EZPilot EVA Version 2.0 User Manual (5697-6961, July 2007)

EZPilot - Management Section Page 36
3. Select the Switch Mgmt. tab and click the Network icon.
4. The EZPilot Manager Switch Settings dialog box appears. You may change the switch’s name,
IP Address, Subnet Mask and Gateway Address from the values entered in the EZPilot SAN
Setup Wizard. If DHCP is supported and enabled, you can check Obtain network settings
automatically. Click OK.
Figure 29: The EZPilot Manager Switch Network Settings dialog box (DHCP supported and enabled)
Note: The current IP address subnet mask and gateway address will be displayed when
the dialog box appears even if the switch is configured to obtain the network settings
automatically.