EMULEX EZPilot EVA Version 2.0 User Manual (5697-6961, July 2007)

EZPilot - Installation Section Page 8
Installing EZPilot to Create a Windows Non-Management
Server
Prerequisites
• If older versions of Emulex, Brocade or HP StorageWorks software were previously installed on
the system you must remove them. Use the Windows Add/Remove Programs feature to remove
the software. If you are prompted to reinstall the Emulex HBA driver during EZPilot installation,
click Yes.
Procedure
To create a non-management server:
1. Install the HBA(s) in the system. Refer to the HBA’s Installation Manual for instructions.
2. Insert the EZPilot CD into the system’s CD-ROM drive.
The EZPilot Installer verification window appears. The window closes automatically when the file
verification process is complete.
The EZPilot EVA Installer welcome page appears.
Figure 7: The EZPilot EVA Installer welcome page
Note: You must install EZPilot on all Windows non-management servers in the SAN.
Caution: Do not install the driver from the CD that shipped with the HBA. EZPilot will install the
necessary driver automatically.
Note: Verification may take several minutes.