H3C LSW1FC4P0 Interface Card for S5820X-28C Ethernet Switches Installation Manual

6
LSW1FC4P0 Card LEDs
The LSW1FC4P0 card has a Power LED and a System LED. The
LED indications are shown in Table 1:
Table 1. Interface Card LED Indications
Power LED
System LED
Status
Steady green
Steady
Maintenance mode
Slow flash (1.5Hz) Normal operation
Quick flash (6Hz)
System boot
Steady red Power failure
Off
Power is off
Off
System failure or the
power is off
Flex Ports
The flex ports are labeled 1−4 (Ext0:1, Ext2:1, Ext3:2, Ext4:3) and
are served by SFP+ optical transceivers. All flex ports are
configured at the factory as 8Gb Fibre Channel transparent fabric
ports (TF_Port), but can be reconfigured as 10Gb converged
enhanced Ethernet ports (PT_Port). Fibre Channel ports can self-
discover devices operating at 8Gb, 4Gb or 2Gb. The LSW1FC4P0
card uses N_Port ID virtualization (NPIV) technology, which
provides transparent Fibre Channel connectivity to any SAN
regardless of vendor.
The flex port LEDs are located above their respective ports and
provide port login and activity status information. The Logged-in
LED indicates the logged-in or initialization status of the connected
devices. After successful completion of the POST, the interface
card extinguishes all Logged-In LEDs. Following a successful port
login, the interface card illuminates the corresponding logged-in