H3C LSW1FC4P0 Interface Card for S5820X-28C Ethernet Switches Installation Manual

29
Installing a Firmware Image (Option 1)
The Image Unpack option unpacks and installs new firmware when
the current firmware has become corrupt. Before using this option,
you must load the new firmware image file onto the interface card.
To install new firmware using this option:
1. Place the switch in maintenance mode. See the procedure for
maintenance mode in “4 Recovering an LSW1FC4P0 Card
Using Maintenance Mode” page 27.
2. Use FTP to load a new firmware image file onto the switch. See
“Custom Firmware Installation” on page 25 for an example of
how to load the image file. When the download is complete,
close the FTP session.
3. Establish a Telnet session with the switch using the default IP
address 10.0.0.1.
telnet 10.0.0.1
4. Enter the maintenance mode account name (prom) and
password (prom), and press Enter.
Switch login: prom
Password: xxxx
5. Select option 1 from the maintenance menu. When prompted
for a file name, enter the firmware image file name:
Image filename: filename
Unpacking ’filename’, please wait...
Unpackage successful.
6. Select option 7, Reset Switch, to reset the interface card and
exit maintenance mode.
Resetting the Network (Option 2)
The Reset Network Config option resets the network properties to
the factory default values and saves them on the interface card.