H3C LSW1FC4P0 Interface Card for S5820X-28C Ethernet Switches Installation Manual

23
Refer to the H3C LSW1FC4P0 Interface Card for S5820X-28C
Ethernet Switches Command Line Interface Guide for information
about the CLI commands.
One-Step Firmware Activation
The Firmware Install and Image Install commands download the
firmware image file from an FTP or TFTP server to the interface
card, unpacks the image file, and performs a disruptive activation in
one step. The installation process prompts you to enter the
following:
• The file transfer protocol (FTP or TFTP)
• IP address of the remote host
• An account name and password on the remote host (FTP only)
• Pathname for the firmware image file
To install firmware using the CLI when a File Transfer Protocol
(FTP) server is present on the management workstation, use the
Firmware Install command. Refer to the H3C LSW1FC4P0
Interface Card for S5820X-28C Ethernet Switch Command Line
Interface Guide for information about the CLI commands.
1. Enter the following commands to download the firmware from a
remote host to the interface card, install the firmware, then reset
the interface card to activate the firmware.
H3C #> admin start
H3C (admin) #> firmware install
The switch will be reset. This process will cause a
disruption to I/O traffic.
Continuing with this action will terminate all
management
sessions, including any Telnet sessions. When the
firmware
activation is complete, you may log in to the switch
again.
Do you want to continue? [y/n]: y
Press 'q' and the ENTER key to abort this command.