H3C LSW1FC4P0 Interface Card for S5820X-28C Ethernet Switches Installation Manual

18
7. Select the corresponding internal port in the faceplate display.
For example, if you are changing flex port Ext1:0, select internal
port Int1:4.
8. Select Port>Port Properties to open the Port Properties dialog
box.
9. Select PT_Port from the Configured Type drop-down list and
click OK. Refer to the H3C LSW1FC4P0 Interface Card for
S5820X-28C Ethernet Switches QuickTools User Guide for
more information.
In the CLI, do the following:
1. Enter the Admin Start and Config Edit commands.
H3C #> admin start
H3C (admin) #> config edit
2. Enter the Set Config Port command for ports Int1:4, Int2:5,
Int3:6, and Int4:7, and remove the flex port (port 1 in this
example) from the PrimaryTFPortMap and
SecondaryTFPortMap parameters. This example assumes that
there is no secondary mapping, which is the default.
H3C (admin-config) #> set config port 4
.
.
.
PrimaryTFPortMap [0,1,2,3 ]0,2,3
H3C (admin-config) #> set config port 5
.
.
.
PrimaryTFPortMap [0,1,2,3 ]0,2,3
H3C (admin-config) #> set config port 6
.
.
.