H3C LSW1FC4P0 Interface Card for S5820X-28C Ethernet Switches Installation Manual

5. Open an Internet browser again and log in with the new IP

address. Refer to the H3C LSW1FC4P0 Interface Card for

S5820X-28C Ethernet Switches QuickTools User Guide for

more information.

To configure the interface card using the CLI, do the following:

1. Open a command window according to the type of workstation

and connection.

2. Open a Telnet session with the default switch IP address

(10.0.0.1) and log in to the switch with the default account name

and password (admin/password).

telnet 10.0.0.1

Switch Login: admin

Password: *******

To insure user account security, you should change the

password for the Admin account name. Refer to the Passwd

command in the H3C LSW1FC4P0 Interface Card for S5820X-

28C Ethernet Switches Command Line Interface Guide.

3. Open an admin session and enter the Set Setup System

command. Enter the values you want for the IP address

(EthNetworkAddress) and the network mask (EthNetworkMask).

For more information about the CLI commands, refer to the H3C

LSW1FC4P0 Interface Card for S5820X-28C Ethernet Switches

Command Line Interface Guide.

H3C #> admin start

H3C (admin) #> set setup system