H3C LSW1FC4P0 Interface Card for S5820X-28C Ethernet Switches Installation Manual

• Indirect Ethernet connection from the management workstation

to the interface card RJ-45 management port through an

Ethernet switch or a hub. This requires a 10/100 Base-T

straight cable.

• Direct Ethernet connection from the management workstation to

the interface card RJ-45 management port. This requires a

10/100 Base-T cross-over cable.

Configuring the LSW1FC4P0 Card

You can configure the interface card using the CLI or QuickTools.

The initial configuration task is to log in and set the interface card IP

address. You may also want to configure the flex ports. You can

also manage an installed LSW1FC4P0 card through the Ethernet

switch CLI.

For information about configuring load balancing, refer to the H3C

S5820X LSW1FC4P0 Release Notes.

Logging into the Interface Card

To log in and configure the interface card using QuickTools, do the

following:

1. Open an Internet browser and enter the default IP address

10.0.0.1 to start the QuickTools web applet.

2. Log in to the interface card using the default user name (admin)

and password (password).

3. Obtain the IP address and subnet mask from your network

administrator.

4. Open the QuickTools Wizards menu and select Configuration

Wizard. Follow the instructions to set the card IP address and

the password. Changing the IP address will terminate the

QuickTools session.