H3C LSW1FC4P0 Interface Card for S5820X-28C Ethernet Switches Installation Manual

5. Configure the S5820X-28C Ethernet card, as needed.

Figure 2. Install an Interface Card

1. Ejector levers

To remove the LSW1FC4P0 Card, do the following:

1. Loosen the captive screws on the LSW1FC4P0 card until all

spring pressure is released.

2. Rotate the card ejector levers outward to unseat the

LSW1FC4P0 Card from the backplane.

3. Gently pull the LSW1FC4P0 Card out of the slot.

4. If you are not replacing the card, install the filler panel to ensure

proper ventilation in the Ethernet switch.