H3C LSW1FC4P0 Interface Card for S5820X-28C Ethernet Switches Installation Manual

10
2 Installation
Caution
To prevent damaging the LSW1FC4P0 card, avoid touching the
components on the card during installation or removal. Wear an
ESD-preventive wrist strap and ESD-preventive gloves when
installing or removing an LSW1FC4P0 card.
Installing the interface card involves the following steps:
1. Install the LSW1FC4P0 card in the Ethernet switch.
2. Install the transceivers.
3. Configure the workstation.
4. Connect the workstation to the LSW1FC4P0 card.
5. Configure the LSW1FC4P0 card.
6. Cable devices to the LSW1FC4P0 card.
Installing the LSW1FC4P0 Card in the
Ethernet Switch
You can install the LSW1FC4P0 Card in an S5820X-28C Ethernet
switch while the switch is operating. The LSW1FC4P0 Card is also
hot-swappable. To install the LSW1FC4P0 Card (Figure 2), do the
following:
1. Choose an empty slot and remove the filler panel.
2. Insert the LSW1FC4P0 Card into the slot along the guide rails
until the card seats on the backplane.
3. Rotate the ejector levers inward to lock the LSW1FC4P0 card in
place.
4. Fasten the captive screws on the LSW1FC4P0 Card.