H3C LSW1FC4P0 Interface Card for S5820X-28C Ethernet Switches Command Line Interface Guide Firmware Version 9.0.7

Switch Module Configuration
Installing Firmware
74 59272-00 C
4. When prompted to install the new firmware, enter Yes to continue or No to
cancel. Entering Yes will disrupt traffic. This is the last opportunity to cancel.
About to install image. Do you want to continue? [y/n] y
Connected to 10.20.20.200 (10.20.20.200).
220 localhost.localdomain FTP server (Version wu-2.6.1-18)
ready.
5. Enter the password for your account name (FTP only).
331 Password required for johndoe.
Password:******
230 User johndoe logged in.
6. The firmware will now be downloaded from the remote host to the Switch
Module, installed, and activated.
Custom Firmware Installation
A custom firmware installation downloads the firmware image file from a remote
host to the Switch Module, unpacks the image file, and resets the Switch Module
in separate steps. This allows you to choose the type of reset and whether the
activation will be disruptive (Reset Switch command) or nondisruptive (Hotreset
command). The following example illustrates a custom firmware installation with a
nondisruptive activation.
1. Download the firmware image file from the workstation to the Switch Module.
 If your workstation has an FTP server, you can enter the Image Fetch
command:
H3C #> admin start
H3C (admin) #> image fetch account_name ip_address
filename
 If your workstation has a TFTP server, you can enter the Image TFTP
command to download the firmware image file.
H3C (admin) #> image tftp ip_address filename