H3C LSW1FC4P0 Interface Card for S5820X-28C Ethernet Switches Command Line Interface Guide Firmware Version 9.0.7

Switch Module Configuration
Installing Firmware
59272-00 C 73
One-Step Firmware Installation
The Firmware Install and Image Install commands download the firmware image
file from an FTP or TFTP server to the Switch Module, unpacks the image file, and
performs a disruptive activation in one step. The one-step installation process
prompts you to enter the following:
 The file transfer protocol (FTP or TFTP)
 IP address of the remote host
 An account name and password on the remote host (FTP only)
 Pathname for the firmware image file
1. Enter the following commands to download the firmware from a remote host
to the Switch Module, install the firmware, then reset the Switch Module to
activate the firmware.
H3C #> admin start
H3C (admin) #> firmware install
The switch will be reset. This process will cause a
disruption to I/O traffic.
Continuing with this action will terminate all management
sessions,including any Telnet sessions. When the firmware
activation is complete, you may log in to the switch again.
Do you want to continue? [y/n]: y
Press 'q' and the ENTER key to abort this command.
2. Enter your choice for the file transfer protocol with which to download the
firmware image file. FTP requires an user account and a password; TFTP
does not.
FTP or TFTP : ftp
3. Enter your account name on the remote host (FTP only) and the IP address
of the remote host. When prompted for the source file name, enter the path
for the firmware image file.
User Account : johndoe
IP Address : 10.0.0.254
Source Filename : 9.0.7.x.x_flcn
About to install image. Do you want to continue? [y/n] y