H3C LSW1FC4P0 Interface Card for S5820X-28C Ethernet Switches Command Line Interface Guide Firmware Version 9.0.7

Switch Module Configuration
Managing Switch Module Configurations
59272-00 C 67
The following is an example of the Set Config Switch command. Refer to Table 19
for a description of the Switch Module configuration parameters.
H3C #> admin start
H3C (admin) #> config edit
H3C (admin-config) #> set config switch
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
AdminState (1=Online, 2=Offline, 3=Diagnostics) [Online ]
SymbolicName (string, max=32 chars) [H3C ]
ConfigDescription (string, max=64 chars) [Default Config]
RequireEnodeMacConfig (True / False) [False ]
Finished configuring attributes.
This configuration must be saved (see config save command) and
activated (see config activate command) before it can take effect.
To discard this configuration use the config cancel command.
H3C (admin-config) #> config save
The config named default has been saved.
H3C (admin) #> config activate
The currently active configuration will be activated.
Please confirm (y/n): [n] y
To make temporary changes to the Switch Module administrative state, enter the
Set Switch State command.