H3C LSW1FC4P0 Interface Card for S5820X-28C Ethernet Switches Command Line Interface Guide Firmware Version 9.0.7

Switch Module Configuration
Managing Switch Module Configurations
66 59272-00 C
Delete a Switch Module Configuration
Enter the Config Delete command to delete a configuration from the Switch
Module as shown in the following example. You cannot delete the active
configuration nor the default configuration (Default Config).
H3C (admin) #> config delete config_2
Modify a Switch Module Configuration
To modify a Switch Module configuration, you must open an Admin session with
the Admin Start command. An Admin session prevents other accounts from
making changes at the same time through Telnet, QuickTools, or another
management application. You must also open a Config Edit session with the
Config Edit command and indicate which configuration you want to modify. If you
do not specify a configuration name the active configuration is assumed.
The Config Edit session provides access to the Set Config commands with which
you make modifications to the port, Switch Module, and port threshold alarm
configuration components as shown:
H3C #> admin start
H3C (admin) #> config edit
The config named default is being edited.
H3C (admin-config)#> set config port . . .
H3C (admin-config)#> set config switch . . .
H3C (admin-config)#> set config threshold . . .
The Config Save command saves the changes you made during the Config Edit
session. In this case, changes to the configuration named Default are being saved
to a new configuration named config_10132003. However, the new configuration
does not take effect until you activate it with the Config Activate command:
H3C (admin-config)#> config save config_10132003
H3C (admin)#> config activate config_10132003
H3C (admin)#> admin end
The Admin End command releases the Admin session for other administrators
when you are done making changes to the Switch Module.