H3C LSW1FC4P0 Interface Card for S5820X-28C Ethernet Switches Command Line Interface Guide Firmware Version 9.0.7

Switch Module Configuration
Managing Switch Module Configurations
59272-00 C 65
Managing Switch Module Configurations
The Switch Module configuration determines the basic operational characteristics
of the Switch Module. A Switch Module supports up to 10 configurations including
the default configuration, named Default Config. The current Switch Module
operating characteristics are determined by the active configuration. Only one
configuration can be active at one time.
Each Switch Module configuration contains Switch Module, port, and port
threshold alarm configuration components. Managing Switch Module
Configurations describes the following tasks:
 Display a List of Switch Module Configurations
 Activate a Switch Module Configuration
 Copy a Switch Module Configuration
 Delete a Switch Module Configuration
 Modify a Switch Module Configuration
 Back Up and Restore a Switch Module Configuration
Display a List of Switch Module Configurations
Enter the Config List command to display the configurations stored on the Switch
Module as show in the following example. Notice that the Config List command
does not require an Admin session.
H3C #> config list
Current list of configurations
------------------------------
default
config_1
config_2
Activate a Switch Module Configuration
Enter the Config Activate command to activate a Switch Module configuration
(config_1) as shown in the following example:
H3C (admin) #> config activate config_1
Copy a Switch Module Configuration
Enter the Config Copy command to create a copy of an existing configuration as
shown in the following example:
H3C (admin) #> config copy config_1 config_2