H3C LSW1FC4P0 Interface Card for S5820X-28C Ethernet Switches Command Line Interface Guide Firmware Version 9.0.7

Network and Fabric Configuration
Configuring Fibre Channel over Ethernet
59272-00 C 39
5. Map Switch Module B internal ports to external ports. Normally, you would
map all internal ports to maximize bandwidth. However, for illustration
purposes, this example maps internal port 4 to external port 0 and maps
internal port 5 to external port 1.
H3C (admin-config) #> set config port 4
Configuring Port Number: 4
------------------------
AdminState (1=Online, 2=Offline, 3=Diagnostics, 4=Down) [Online ]
PortType (PT,TH) [TH ]
EthLinkSpeed (10=10Gb/s) [10Gb/s ]
PrimaryTFPortMap (decimal value for port, N=no mapping) [0,1,2,3 ] 0
BackupTFPortMap (decimal value for port, N=no mapping) [None ]
SymPortName (string, max=32 chars) [Port4 ]
DCBXEnabled (True / False) [True ]
PfcPriority (decimal value, 0-7) [3 ]
H3C (admin-config) #> set config port 5
Configuring Port Number: 5
------------------------
AdminState (1=Online, 2=Offline, 3=Diagnostics, 4=Down) [Online ]
PortType (PT,TH) [TH ]
EthLinkSpeed (10=10Gb/s) [10Gb/s ]
PrimaryTFPortMap (decimal value for port, N=no mapping) [0,1,2,3 ] 1
BackupTFPortMap (decimal value for port, N=no mapping) [None ]
SymPortName (string, max=32 chars) [Port5 ]
DCBXEnabled (True / False) [True ]
PfcPriority (decimal value, 0-7) [3 ]
Finished configuring attributes.
This configuration must be saved (see config save command) and
activated (see config activate command) before it can take effect.
To discard this configuration use the config cancel command.