H3C LSW1FC4P0 Interface Card for S5820X-28C Ethernet Switches Command Line Interface Guide Firmware Version 9.0.7

Network and Fabric Configuration
Configuring Fibre Channel over Ethernet
30 59272-00 C
To configure Switch Module A:
1. Open a Config Edit session.
H3C #> admin start
H3C (admin) #> config edit
2. Create a VLAN and an FCF, and assign the VLAN to the FCF. This example
uses the default VLAN 1002. If you want a different VLAN number, you can
create one.
H3C (admin-config) #> fcf 0efc01 create
H3C (admin-config) #> fcf 0efc01 add vlan 1002
3. Assign internal ports to VLAN 1002. Because all internal ports (4–7) are
assigned to VLAN 1002 by default, no further configuration is needed.
4. Map Switch Module A internal ports to the external ports. Normally, you
would map all internal ports to maximize bandwidth. However for illustration
purposes, this example maps internal ports 4 and 5 each to external ports 0
and 1.
H3C (admin-config) #> set config port 4
Configuring Port Number: 4
------------------------
AdminState (1=Online, 2=Offline, 3=Diagnostics, 4=Down) [Online ]
PortType (PT,TH) [TH ]
EthLinkSpeed (10=10Gb/s) [10Gb/s ]
PrimaryTFPortMap (decimal value for port, N=no mapping) [0,1,2,3 ] 0,1
BackupTFPortMap (decimal value for port, N=no mapping) [None ]
SymPortName (string, max=32 chars) [Port4 ]
DCBXEnabled (True / False) [True ]
PfcPriority (decimal value, 0-7) [3 ]
H3C (admin-config) #> set config port 5
Configuring Port Number: 5
------------------------
AdminState (1=Online, 2=Offline, 3=Diagnostics, 4=Down) [Online ]
PortType (PT,TH) [TH ]
EthLinkSpeed (10=10Gb/s) [10Gb/s ]
PrimaryTFPortMap (decimal value for port, N=no mapping) [0,1,2,3 ] 0,1
BackupTFPortMap (decimal value for port, N=no mapping) [None ]
SymPortName (string, max=32 chars) [Port5 ]
DCBXEnabled (True / False) [True ]
PfcPriority (decimal value, 0-7) [3 ]
Finished configuring attributes.
This configuration must be saved (see config save command) and
activated (see config activate command) before it can take effect.
To discard this configuration use the config cancel command.