H3C LSW1FC4P0 Interface Card for S5820X-28C Ethernet Switches Command Line Interface Guide Firmware Version 9.0.7

Network and Fabric Configuration
Configuring Fibre Channel over Ethernet
28 59272-00 C
To configure the Ethernet Switch:
1. Enter System View.
system-view
2. Create VLAN 1002 for the Fibre Channel fabric.
vlan 1002
3. Enable LLDP function.
system-view
lldp enable
4. Enable APP function.
acl number 4000
rule 0 permit type 8906 ffff
rule 1 permit type 8914 ffff
traffic classifier fcoe operator or
if-match acl 4000
traffic behavior fcoe
remark dot1p 3
qos policy fcoe
classifier fcoe behavior fcoe mode dcbx
5. Enable VLAN 1002 and DCBX/PFC/APP function on the Ethernet switch
external and internal ports.
External Ports:
interface Ten-GigabitEthernet1/0/1
port link-type trunk
port trunk permit vlan 1 1002
priority-flow-control auto
priority-flow-control no-drop dot1p 3
qos apply policy fcoe outbound
qos trust dot1p
lldp tlv-enable dot1-tlv dcbx
quit
interface Ten-GigabitEthernet1/0/2
port link-type trunk
port trunk permit vlan 1 1002
priority-flow-control auto