H3C LSW1FC4P0 Interface Card for S5820X-28C Ethernet Switches Command Line Interface Guide Firmware Version 9.0.7

Network and Fabric Configuration
Configuring Fibre Channel over Ethernet
24 59272-00 C
Modifying FCoE Forwarders
To modify an FCoE forwarder, use the Fcf Edit command as shown in the
following example:
H3C #> admin start
H3C (admin) #> config edit
The config named default is being edited.
H3C (admin-config) #> fcf 0efc01 edit
A list of attributes with formatting and default values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Default Values:
EnforceKeepAliveTimer True
KeepAliveTimer 8
FIPPriority 128
New Value (press ENTER to accept current value, 'q' to quit):
EnforceKeepAliveTimer (True / False) :
KeepAliveTimer (decimal value, 8-90) :
FIPPriority (decimal value, 0-255) :
The FCF (FCoE Forwarder) has been created.
This configuration must be saved with the 'config save' command
before it can take effect, or to discard this configuration
use the 'config cancel' command.
H3C (admin-config) #> config save
The config named default has been saved.
H3C (admin) #> config activate
The currently active configuration will be activated.
Please confirm (y/n): [n] y