H3C LSW1FC4P0 Interface Card for S5820X-28C Ethernet Switches Command Line Interface Guide Firmware Version 9.0.7

Network and Fabric Configuration
Configuring Fibre Channel over Ethernet
18 59272-00 C
Creating Virtual LANs
The Switch Module comes from the factory configured with all internal ports (4–7)
in the default VLAN 1002. You can create up to four additional VLANs for a
maximum total of five. To create additional VLANs, use the Vlan Create command
as shown in the following example.
H3C (admin) #> admin start
H3C (admin) #> config edit
The config named default is being edited.
H3C (admin-config) #> vlan 1003 create
The VLAN has been created.
This configuration must be saved (see 'config save' command) and
activated (see 'config activate' command) before it can take effect.
To discard this configuration use the 'config cancel' command.
H3C (admin-config) #> config save
The config named default has been saved.
H3C (admin) #> config activate
The currently active configuration will be activated.
Please confirm (y/n): [n] y