H3C LSW1FC4P0 Interface Card for S5820X-28C Ethernet Switches Command Line Interface Guide Firmware Version 9.0.7

Network and Fabric Configuration
Configuring Fibre Channel over Ethernet
59272-00 C 17
Configuring Fibre Channel over Ethernet
The Switch Module is capable of passing FCoE traffic through the configuration of
virtual local area networks (VLANs) and FCoE forwarders (FCFs). This section
describes the configuration tasks and provides examples of how to configure the
Ethernet switch and the Switch Module for one and two SAN fabrics.
 Fibre Channel over Ethernet Tasks
 Configuring the Ethernet Switch and the Switch Module
Fibre Channel over Ethernet Tasks
 Displaying Virtual LAN Information
 Creating Virtual LANs
 Deleting Virtual LANs
 Adding Ports to a Virtual LAN
 Removing Ports from a Virtual LAN
 Displaying FCoE Forwarder Information
 Creating FCoE Forwarders
 Deleting FCoE Forwarders
 Adding MAC Addresses to an FCoE Forwarder
 Adding a VLAN to an FCoE Forwarder
 Removing MAC Addresses from an FCoE Forwarder
 Removing VLANs from an FCoE Forwarder
Displaying Virtual LAN Information
To display VLAN information, use the Vlan List command. You can display the
following information:
 Active—configuration that is in use (default)
 Configured—configuration that resides in volatile memory
 Edited—configuration residing in volatile memory that has not been saved
The following is an example of the Vlan List command:
H3C (admin) #> vlan list active
Active VLAN Information
VLAN 1002
Ports 4-7