H3C LSW1FC4P0 Interface Card for S5820X-28C Ethernet Switches Command Line Interface Guide Firmware Version 9.0.7

Command Reference
Show Port
268 59272-00 C
ClassXToss Number of times an SOFi3 or SOFn3 frame is tossed from
TBUF.
ConfigType Configured port type
DecodeError Number of decode errors detected
DiagFaultCode Fault code from the most recent Power-on self test
DiagStatus Status from the most recent Power-on self test
EpConnects Not applicable
EpConnState Not applicable
EpIsoReason Not applicable
FBusy Number of times the Switch Module sent a F_BSY because
Class 2 frame could not be delivered within ED_TOV time.
Number of class 2 and class 3 fabric busy (F_BSY) frames
generated by this port in response to incoming frames. This
usually indicates a busy condition on the fabric or N_Port that
is preventing delivery of this frame.
Flowerrors Number of frames received there were no available credits.
FReject Number of frames from devices that were rejected.
InvalidCRC Invalid CRC detected.
InvalidDestAddr Invalid destination address detected.
Link Failures Number of optical link failures detected by this port. A link fail-
ure is a loss of synchronization or a loss of signal while not in
the offline state. A loss of signal causes the Switch Module to
attempt to re-establish the link. If the link is not re-established,
a link failure is counted. A link reset is performed after a link
failure.
LinkSpeed Port transmission speed
LinkState Port activity status
LIP_AL_PD_ALPS Number of F7, AL_PS LIPs, or AL_PD (vendor specific)
resets, performed.
LIP_F7_AL_PS This LIP is used to reinitialize the loop. An L_Port, identified by
AL_PS, may have noticed a performance degradation and is
trying to restore the loop.
Table 35. Show Port Parameters (Continued)
Entry Description