H3C LSW1FC4P0 Interface Card for S5820X-28C Ethernet Switches Command Line Interface Guide Firmware Version 9.0.7

Command Reference
Set Setup System
240 59272-00 C
The following is an example of the Set Setup System Ntp command:
H3C (admin) #> set setup system ntp
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Current Values:
NTPClientEnabled False
NTPServerDiscovery Static
NTPServerAddress 10.20.10.10
New Value (press ENTER to accept current value, 'q' to quit, 'n' for none):
NTPClientEnabled (True / False) :
NTPServerDiscovery (1=Static, 2=Dhcp, 3=Dhcpv6) :
NTPServerAddress (hostname, IPv4, or IPv6 Address) :
Do you want to save and activate this system setup? (y/n): [n]
The following is an example of the Set Setup System Timers command:
H3C (admin) #> set setup system timers
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Current Values:
AdminTimeout 30
InactivityTimeout 0
New Value (press ENTER to accept current value, 'q' to quit):
AdminTimeout (dec value 0-1440 minutes, 0=never) :
InactivityTimeout (dec value 0-1440 minutes, 0=never) :
Do you want to save and activate this system setup? (y/n): [n]