H3C LSW1FC4P0 Interface Card for S5820X-28C Ethernet Switches Command Line Interface Guide Firmware Version 9.0.7

Command Reference
Set Setup System
236 59272-00 C
ntp
Prompts you in a line-by-line fashion to change the NTP server configuration
parameters described in Table 31. To configure all system parameters, omit the
keyword. For each parameter, enter a new value or press the Enter key to accept
the current value.
timers
Prompts you in a line-by-line fashion to change the timer configuration parameters
described in Table 32. To configure all system parameters, omit the keyword. For
each parameter, enter a new value or press the Enter key to accept the current
value.
Table 31. NTP Server Configuration Parameters
Parameter Description
NTPClientEnabled Enables (True) or disables (False) the Network Time Pro-
tocol (NTP) client on the switch. This client enables the
switch to synchronize its time with an NTP server. This
feature supports NTP version 4 and is compatible with
version 3. An Ethernet connection to the server is
required and you must first set an initial time and date on
the switch. The synchronized time becomes effective
immediately. The default is False.
NTPServerDiscovery Ethernet boot method: 1 - Static, 2 - DHCP, 3 - DHCPv6.
The default is 1 - Static.
NTPServerAddress The IP address or DNS host name of the NTP server from
which the NTP client acquires the time and date. The
default is 10.0.0.254.
Table 32. Timer Configuration Parameters
Parameter Description
AdminTimeout Amount of time in minutes the switch waits before termi-
nating an idle Admin session. Zero (0) disables the time
out threshold. The default is 30, the maximum is 1440.
InactivityTimeout Amount of time in minutes the switch waits before termi-
nating an idle Telnet command line interface session.
Zero (0) disables the time out threshold. The default is 10,
the maximum is 1440.