H3C LSW1FC4P0 Interface Card for S5820X-28C Ethernet Switches Command Line Interface Guide Firmware Version 9.0.7

Command Reference
Set Setup System
234 59272-00 C
ipv4
Prompts you in a line-by-line fashion to change the switch IPv4 Ethernet
configuration parameters described in Table 28. To configure all system
parameters, omit the keyword. For each parameter, enter a new value or press
the Enter key to accept the current value.
ipv6
Prompts you in a line-by-line fashion to change the switch IP version 6 Ethernet
configuration parameters described in Table 29. To configure all system
parameters, omit the keyword. For each parameter, enter a new value or press
the Enter key to accept the current value.
NOTE:
Changing the IP address will terminate all Ethernet management sessions.
Table 28. IP Version 4 Ethernet Configuration Parameters
Entry Description
EthIPv4NetworkEnable Enables (True) or disables (False) the IP version 4 inter-
face. The default is True.
EthIPv4NetworkDiscovery Ethernet boot method: 1—Static, 2—Bootp, 3—DHCP,
4—RARP. The default is 1—Static.
EthIPv4NetworkAddress Ethernet IP address. The default is 10.0.0.1.
EthIPv4NetworkMask Ethernet IP subnet mask address. The default is
255.0.0.0.
EthIPv4GatewayAddress Ethernet address gateway. The default is 10.0.0.254
NOTE:
Changing the IP address will terminate all Ethernet management sessions.