H3C LSW1FC4P0 Interface Card for S5820X-28C Ethernet Switches Command Line Interface Guide Firmware Version 9.0.7

Command Reference
Set Port
216 59272-00 C
Set Port
Sets port state and speed for the specified port temporarily until the next Switch
Module
reset or new configuration activation. This command also clears port
counters.
Authority Admin session
Syntax set port clear
or
set port [port_number]
clear
speed [transmission_speed]
state [state]
Keywords [port_number]
Specifies the port. External ports are numbered 0–3; internal ports are numbered
4–7.
clear
Clears the counters on all ports or the port given by [port_number].
speed [transmission_speed]
Specifies the transmission speed for the specified port. Choose one of the
following port speed values:
1Gb/s
One gigabit per second. This value applies only to TF_Ports.
2Gb/s
Two gigabits per second. This value applies only to TF_Ports.
4Gb/s
Four gigabits per second. This value applies only to TF_Ports.
8Gb/s
Eight gigabits per second. This value applies only to TF_Ports.
10Gb/s
10 gigabits per second. This value applies only to TH_Ports and PT_Ports.
Auto
The port speed is automatically detected. This value applies only to
TF_Ports.