H3C LSW1FC4P0 Interface Card for S5820X-28C Ethernet Switches Command Line Interface Guide Firmware Version 9.0.7

Command Reference
Set Config Switch
206 59272-00 C
Set Config Switch
Sets the Switch Module configuration parameters. The changes you make with
this command are not retained when you reset or power cycle the Switch Module
unless you save them using the Config Save command.
Authority Admin session and a Config Edit session
Syntax set config switch
This command initiates an editing session in which to change Switch Module
configuration settings. The system displays each parameter one line at a time and
prompts you for a value. For each parameter, enter a new value or press the Enter
key to accept the current value shown in brackets. Table 19 describes the Switch
Module configuration parameters.
Table 19. Switch Module Configuration Parameters
Parameter Description
AdminState Switch Module administrative state.
 Online: Activates and prepares the ports to send data.
This is the default.
 Offline: Prevents the ports from receiving signal and
accepting a device login.
 Diagnostics: Prepares the ports for testing and prevents
the ports from accepting a device login.
SymbolicName Descriptive name for the Switch Module. The name can be
up to 32 characters excluding #, semicolon (;), and comma
(,). The default is H3C.
ConfigDescription Switch Module configuration description. The configuration
description can be up to 32 characters excluding #, semi-
colon (;), and comma (,). The default is Default Config.
RequireEnodeMacConfig Enables (True) or disables MAC-address checking on the
switch. This parameter is enabled when connecting to
more than one Fibre Channel fabric to ensure that each
FCF responds to one and only one CNA.