H3C LSW1FC4P0 Interface Card for S5820X-28C Ethernet Switches Command Line Interface Guide Firmware Version 9.0.7

Command Reference
Set Config Port
59272-00 C 203
LinkSpeed
(external ports only)
Transmission speed:
 TF_Ports: 1-Gbps, 2-Gbps, 4-Gbps, 8-Gbps, or Auto. Auto
acquires the speed of the connected device. The default is
Auto. Setting a port to 1-Gbps that has an 8-Gbps SFP will
down the port.
 TH_Ports: 10Gb/s
 PT_Ports: 10Gb/s
SymPortName Descriptive name for the port. The name can be up to 32
characters excluding #, semicolon (;), and comma (,). The
default is Port n where n is the port number. This parameter
can be changed only with the Set Config Port command.
EthLinkSpeed
(internal ports only)
10Gb/s
PrimaryTFPortMap
(internal TH_Ports only)
Primary mapping for TH_Ports. The mapping consists of a list
of TF_Port numbers (delimited by spaces) that are assigned
to pass traffic to and from the TH_Port. If you specify N, the
TH_Port is unmapped, effectively disconnecting the TH_Port
from the fabric. By default, each internal port (4–7) is mapped
to every external port (1–3).
If all TF_Ports in the primary mapping fail, the backup port
mapping is used (BackupTFPortMap).
When a list is specified, the Switch Module distributes the
host NPIV logins across the TF_Ports in a round-robin fash-
ion for better performance.
BackupTFPortMap
(internal TH_Ports only)
Backup mapping for TH_Ports. The mapping consists of a list
of TF_Port numbers (delimited by spaces) that are assigned
to pass traffic to and from the TH_Port when all TF_Ports in
the primary mapping (PrimaryTFPortMap) have failed. If you
specify N, the TH_Port is unmapped, effectively disconnect-
ing the TH_Port from the fabric. The default is no mapping
(N).
When a list is specified, the Switch Module distributes the
host NPIV logins across the TF ports in a round-robin fashion
for better performance.
DCBXEnabled
(internal TH_Ports only)
Enables (True) or disables (False) the data center bridging
capability exchange protocol (DCBX). The default is True.
PfcPriority
(internal TH_Ports only)
Sets the priority (0–7) for priority-based flow control. The
default is 3.
Table 18. Port Configuration Parameters (Continued)
Parameter Description