H3C LSW1FC4P0 Interface Card for S5820X-28C Ethernet Switches Command Line Interface Guide Firmware Version 9.0.7

Command Reference
Reset
59272-00 C 193
radius
Resets the RADIUS configuration to the default values as described in Table 15.
services
Resets the
Switch Module services configuration to the default values as described
in Table 16.
snmp
Resets the SNMP configuration settings to the factory default values. Refer to
Table 14 for SNMP configuration default values.
switch
Resets the
Switch Module without a power-on self test. This is the default. This
reset disrupts traffic and does the following:
 Activates the pending firmware.
 Closes all management sessions.
 Clears the event log. To save the event log before resetting, refer to the
“Set Log” command on page 11-210.
To reset the
Switch Module with a power-on self test, refer to the “Hardreset”
command on page 11-162. To reset the
Switch Module without disrupting traffic,
refer to the “Hotreset” command on page 11-165.
system
Resets the system configuration settings to the factory default values as
described in Table 17.
NOTE:
Because this keyword changes network parameters, the workstation
could lose communication with the
Switch Module.