H3C LSW1FC4P0 Interface Card for S5820X-28C Ethernet Switches Command Line Interface Guide Firmware Version 9.0.7

Command Reference
Admin
59272-00 C 135
Admin
Opens and closes an Admin session. The Admin session provides access to
commands that change module configurations. Only one Admin session can be
open on the module at any time. An inactive Admin session will time out after a
period of time which can be changed using the Set Setup System command.
Authority User account with Admin authority
Syntax admin
start (or begin)
end (or stop)
cancel
Keywords start (or begin)
Opens the Admin session
end (or stop)
Closes the Admin session. The Hardreset, Hotreset, Quit, and Reset Switch
commands will also end an Admin session.
cancel
Terminates an Admin session opened by another user. Use this keyword with care
because it terminates the Admin session without warning the other user and
without saving pending changes.
Notes Closing a Telnet window during an Admin session does not release the session. In
this case, you must either wait for the Admin session to time out, or use the Admin
Cancel command.
Examples The following example shows how to open and close an Admin session:
H3C #> admin start
H3C (admin) #>
.
.
.
H3C (admin) #> admin end