H3C LSW1FC4P0 Interface Card for S5820X-28C Ethernet Switches Command Line Interface Guide Firmware Version 9.0.7

59272-00 C 133
11 Command Reference
This section describes the commands of the CLI and the format in which they are
presented. The command format presents the following:
 Access Authority
 Syntax and Keywords
 Notes and Examples
The commands are listed in “Command Listing” on page 134.
Access Authority
The Authority paragraph in each command description indicates what types of
sessions are required to enter that command. Commands associated with
monitoring tasks are available to all account names with no special session
requirement. Commands associated with configuration tasks are available only
within an Admin session. An account must have Admin authority to enter the
Admin Start command, which opens an Admin session.
Some commands require that you open additional editing sessions within an
Admin session. Commands that modify the
Switch Module configuration require a
Config Edit session, which is opened by the Config Edit command. These
command include all of the Set Config commands.
 Commands that modify the Call Home e-mail notification configuration
require a Callhome Edit session, which is opened by the Callhome Edit
command. These commands include the Callhome and Profile commands.
 Commands that modify the Internet Protocol Security configuration require
an Ipsec Edit session, which is opened by the Ipsec Edit command. These
commands include the Ipsec, Ipsec Association and Ipsec Policy
commands.