H3C LSW1FC4P0 Interface Card for S5820X-28C Ethernet Switches Command Line Interface Guide Firmware Version 9.0.7

59272-00 C 125
10 Simple Network
Management Protocol
Configuration
This section describes the following tasks:
 Managing the SNMP Service
 Displaying SNMP Information
 Modifying the SNMP Configuration
 Resetting the SNMP Configuration
 Managing the SNMP Version 3 Configuration
The Simple Network Management Protocol (SNMP) provides for the management
of the Switch Module through third-party applications that use SNMP. Security
consists of a read community string and a write community string that serve as
passwords that control read and write access to the switch. These strings are set
at the factory to well-known defaults and should be changed if SNMP is to be
enabled. The switch supports SNMP version 3 in the CLI, which is disabled by
default.
Managing the SNMP Service
You control the SNMP service SNMPEnabled parameters through the
Set Setup SNMP or Set Setup Services commands. Refer to “Modifying the
SNMP Configuration” on page 10-128 for more information.