H3C LSW1FC4P0 Interface Card for S5820X-28C Ethernet Switches Command Line Interface Guide Firmware Version 9.0.7

59272-00 C 1
1 Command Line Interface
Usage
Your Switch Module contains an embedded Telnet server. This server enables a
Telnet client to establish a Telnet session with the Switch Module to retrieve
information or to configure parameters using the CLI. You can use the CLI to
perform a variety of fabric and Switch Module management tasks through an
Ethernet connection to your server unit. You can access the Telnet interface in two
ways:
 Using your server management interface
 From a command-line window on a connected network management
workstation
This section describes the following tasks:
 Logging In to the Switch Module
 Opening and Closing an Admin Session
 Entering Commands
 Getting Help
 Setting Page Breaks
 Creating a Support File
 Downloading and Uploading Files
NOTE:
Before you configure your Switch Module, be sure that the management
modules in your server unit are properly configured. In addition, to accessing
and managing your Switch Module from an external environment, you might
need to enable certain features, such as the external ports and external
management over all ports. For more detailed information about configuring
your management module, see your server Installation Guide.