H3C LSW1FC4P0 Interface Card for S5820X-28C Ethernet Switches Command Line Interface Guide Firmware Version 9.0.7

Port Configuration
Mapping Transparent Fabric Ports
59272-00 C 89
Mapping Transparent Fabric Ports
TF_Port mapping assigns one or more TF_Ports to pass traffic to and from a
specified TH_Port. You can specify a primary mapping and a backup mapping for
each TH_Port. If all TF_Ports in the primary mapping fail, the backup mapping is
used. In the default primary TF_Port mapping, each internal port (4–7) is mapped
to every external port (0–3). The default backup TF_Port mapping is undefined.
The following example defines a backup mapping for port 4:
H3C #> admin start
H3C (admin) #> config edit
H3C (admin-config) #> set config port 4
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Configuring Port Number: 4
------------------------
AdminState (1=Online, 2=Offline, 3=Diagnostics, 4=Down) [Online ]
PortType (PT,TH) [TH ]
EthLinkSpeed (10=10Gb/s) [10Gb/s ]
PrimaryTFPortMap (decimal value for port, N=no mapping) [0,1,2,3 ]
BackupTFPortMap (decimal value for port, N=no mapping) [None ] 0,1
SymPortName (string, max=32 chars) [Port4 ]
DCBXEnabled (True / False) [True ]
PfcPriority (decimal value, 0-7) [3 ]
Finished configuring attributes.
This configuration must be saved (see config save command) and
activated (see config activate command) before it can take effect.
To discard this configuration use the config cancel command.
H3C (admin-config) #> config save
The config named default has been saved.
H3C (admin) #> config activate
The currently active configuration will be activated.
Please confirm (y/n): [n] y