64-Bit/66 MHz Single Channel Wide Ultra3 SCSI Adapter Installation Guide

3-10 Compaq 64-Bit/66 MHz Single Channel Wide Ultra3 SCSI Adapter Installation Guide
Compaq Confidential – Need to Know Required
Writer:
John Turner
Project:
Compaq 64-Bit/66 MHz Single Channel Wide Ultra3 SCSI Adapter Installation Guide
Comments:
Part Number:
154060-002
File Name:
d-ch3 Installing Firmware and Software.doc
Last Saved On:
7/21/00 2:23 PM
3. Insert the SmartStart and Support Software CD into the CD drive.
4. Copy the following files from the subdirectory
\CPQSUPSW\NSSD\NWPA into your NetWare directory:
ADPT160.HAM
ADPT160.DDI
5. Remove the CD and shutdown the system.
6. Install the Compaq 64-Bit/66-MHz Single Channel Wide Ultra3 SCSI
Adapter.
7. Power on the system and start NetWare 5.1.
NetWare will detect the new adapter and will attempt to load the driver.
8. Follow the screen prompts to load the driver ADPT160.HAM.
9. When presented with a list of drivers, select the driver and press Esc to
load it.
NOTE:
Although the
Esc
option is not shown on this screen, you must use it in order to
load the driver. Pressing
Enter
will not load the driver.
IBM OS/2
Use the following instructions to install the 64-Bit/66-MHz Single Channel
Wide Ultra3 SCSI Adapter driver on a system already running IBM OS/2. The
driver file, named AICU160.ADD, is located on the SmartStart and Support
Software CD supplied with your new 64-Bit/66-MHz Single Channel Wide
Ultra3 SCSI Adapter.
1. Insert the Smart Start and Support Software CD (version 4.80 or later)
into a system and reboot. This CD launches the application
automatically.
2. At the System Utilities screen, click OK.
3. Choose the option Create Software Diskettes From CD Only and move
to the next screen.