64-Bit/66 MHz Single Channel Wide Ultra3 SCSI Adapter Installation Guide

3-2 Compaq 64-Bit/66 MHz Single Channel Wide Ultra3 SCSI Adapter Installation Guide
Compaq Confidential – Need to Know Required
Writer:
John Turner
Project:
Compaq 64-Bit/66 MHz Single Channel Wide Ultra3 SCSI Adapter Installation Guide
Comments:
Part Number:
154060-002
File Name:
d-ch3 Installing Firmware and Software.doc
Last Saved On:
7/21/00 2:23 PM
Upgrading the System ROM
System ROM can be upgraded by flashing the ROM using a special Compaq
utility called System ROMPaq. This utility replaces the existing contents of
the ROM with another version stored in a disk file. Use the information below
to access and run System ROMPaq.
ROMPaq Diskettes
The ROMPaq utilities must be run from diskette. The latest version of the
ROMPaq diskette can be created from the Compaq SmartStart and Support
Software CD that was supplied with your 64-Bit/66 MHz Single Channel
Wide Ultra3 SCSI Adapter option kit. Use the latest version of ROMPaq
because it most effectively supports your new 64-Bit/66 MHz Single Channel
Wide Ultra3 SCSI Adapter.
Materials Needed
You will need the following items to create a System ROMPaq utility diskette:
■
Compaq SmartStart and Support Software CD (supplied in
64-Bit/66 MHz Single Channel Wide Ultra3 SCSI Adapter option kit)
■
One blank diskette
■
Access to a server with a bootable CD-ROM drive
Creating Diskettes
To create a ROMPaq diskette:
1. Boot the computer from the Compaq SmartStart and Support Software
CD.
2. From the Compaq System Utilities screen select Create Support
Software.
3. At the Diskette Builder screen, select the appropriate option for your
server model.
4. Follow the instructions on the screen to create the ROMPaq diskette.