HP ProCurve Series 6120 Blade Switches IPv6 Configuration Guide

Getting Started
To Set Up and Install the Switch in Your Network
Note To access the online Help for the ProCurve web browser interface, you need
either ProCurve Manager (version 1.5 or greater) installed on your network
or an active connection to the World Wide Web. Otherwise, Online help for the
web browser interface will not be available.
Online help is also accessible by logging into the Onboard Administrator.
The Help Button
Figure 1-5. Button for Onboard Administrator Interface Online Help
To Set Up and Install the Switch in Your
Network
Use the ProCurve Installation and Getting Started Guide for the following:
■ Notes, cautions, and warnings related to installing and using the switch
and its related modules
■ Instructions for physically installing the switch in your network
■ Quickly assigning an IP address and subnet mask, set a Manager pass-
word, and (optionally) configure other basic features.
■ Interpreting LED behavior.
For the latest version of the Installation and Getting Started Guide for your
switch, refer to “Getting Documentation From the Web” on page 1-6.
1-8