HP ProCurve Series 6120 Blade Switches IPv6 Configuration Guide

Getting Started
Introduction
Introduction
This guide is intended for use with the HP ProCurve 6120G/XG and 6120GX
switches.
It describes how to use the command line interface (CLI) to configure,
manage, monitor, and troubleshoot switch operation. For an overview of other
product documentation for the above switches, refer to “Product Documen-
tation” on page xi. You can download documentation from the following web
sites:
www.procurve.com/manuals
www.hp.com/go/bladesystem/documentation
h18004.www1.hp.com/products/blades/components/c-class-tech-installing.html
Conventions
This guide uses the following conventions for command syntax and displayed
information.
Command Syntax Statements
Syntax: ip < default-gateway < ip-addr >> | routing >
Syntax: show interfaces [port-list ]
■ Vertical bars ( | ) separate alternative, mutually exclusive elements.
■ Square brackets ( [ ] ) indicate optional elements.
■ Braces ( < > ) enclose required elements.
■ Braces within square brackets ( [ < > ] ) indicate a required element within
an optional choice.
■ Boldface indicates use of a CLI command, part of a CLI command syntax,
or other displayed element in general text. For example:
“Use the copy tftp command to download the key from a TFTP server.”
■ Italics indicate variables for which you must supply a value when execut-
ing the command. For example, in this command syntax, you must provide
one or more port numbers:
Syntax: telnet < ipv6-address >
1-2