HP ProCurve Series 6120 Blade Switches IPv6 Configuration Guide

IPv6 Management Features
TFTP File Transfers Over IPv6
Using TFTP to Copy Files over IPv6
Use the TFTP copy commands described in this section to:
■ Download specified files from a TFTP server to a switch on which TFTP
client functionality is enabled.
■ Upload specified files from a switch, on which TFTP server functionality
is enabled, to a TFTP server.
Syntax: copy tftp < target > < ipv6-addr > < filename > [oobm]
Copies (downloads) a data file from a TFTP server at the
specified IPv6 address to a target file on a switch that is
enabled with TFTP server functionality.
< ipv6-addr >: If this is a link-local address, use this IPv6
address format:
fe80::< device-id >%vlan< vid >
For example:
fe80::123%vlan10
If this is a global unicast or anycast address, use this IPv6
format:
< ipv6-addr >
For example:
2001:db8::123
< target > is one of the following values:
■ autorun-cert-file: Copies an autorun trusted certificate to
the switch.
■ autorun-key-file: Copies an autorun key file to the switch.
■ config < filename >: Copies the contents of a file on a
remote host to a configuration file on the switch.
■ flash < primary | secondary >: Copies a software file stored
on a remote host to primary or secondary flash memory
on the switch. To run a newly downloaded software
image, enter the reload or boot system flash command.
■ pub-key-file: Copies a public-key file to the switch.
■ startup-config: Copies a configuration file on a remote
host to the startup configuration file on the switch.
oobm: For switches that have a separate out-of-band manage-
ment port, specifies that the transfer will be through the out-
of-band management interface. (Default is transfer through
the data interface.)
5-19